rock cod

ive had cow crap fly in my eye a few times .. later i could smell and taste it same time , but not as bad a pile of purged husky

did you taste some husky ..or epol??

Laughing dude ... get UST mountain king 2.2 , you will have good drip in the front & less rolling resistance on the rear!! clup the trails.

Best patches i have used for reparing cuts up to 3cm long , buy the MARUNI patch kits bout 20 bucks ,remove the sealant latex granules inside of the tyre wall by gently sanding the cut area patch the tyre from the inside leave the plastic film on .. Super glue for the beading ?? eish , does not gratf at all .. best solution for getting the beads to "crack" eeee uma sunlight soap!! dip your fingers in the soap & water solution run along the BEADING of the tyre only .. another way of pumping the tyre up when you are in a place where there is no petrol station or Co2 bombs left , & you really want to ride tubeless...is cut an old tube in vertically in half , rap it around the tyre on the rim , ensure it is centered this creates a small vacuum of air in the centre , so when air is pumped ..with a foot pump air moves faster to the tyre bead & should hopefully hook onto the rim lip.. when in doubt this has worked on a few mtb trips in the transkei..

Stans yellow rim tape , with a tubeless valve.with Stans sealant . good to go .. rim strip valves tend to tear off after a few months ..