zappa Posted August 20, 2014 Share Have removed black plastic lug where you insert new cable. When I push old cable out, it changes the gear, wont come out. Have tried clicking up and down but nothing working. Edited August 20, 2014 by zappa Link to comment Share on other sites More sharing options...
droo Posted August 20, 2014 Share Shift down to the lowest gear (all the cable released) and try again. If that doesn't work, try twisting the cable to free it up, it should come out. Link to comment Share on other sites More sharing options...
zappa Posted August 20, 2014 Share Thanks Droo, tried that. There seems to be a black plastic "thingy" in the way, preventing cable from being pushed out. Link to comment Share on other sites More sharing options...
Guest CHRIS001 Posted August 20, 2014 Share Hi look if u have the setting under your leaver that shows 2x or 3x under the leaver . if u do have shift that it would be in the lowest, the change it form 2x to 3x then push the cable out. (front shifter). Link to comment Share on other sites More sharing options...
zappa Posted August 20, 2014 Share Thanks Chris Take tomorrow off and have a beer! thanks, Thats what it was. Also when in doubt, RTFM (read the manual) < For Front >2 × 101. Switch the mode converter to the 3x (triple mode) position, and then check the lowest position. Operate lever (B) two times or more to set the lever to the lowest position. Remove the inner hole cover, and install the cable.Note:Do not force the mode select switch to turn. If you force it to turn, it will break.< XTR / DEORE XT >Mode converterMode select switch< SLX / DEORE >Mode converterMode select switchInner hole coverLever (B)Inner cable122. Operate lever (A) once to set it to the middle position. Switch the mode converter to the 2x (double mode) position.Note:The mode converter cannot be switched while the lever is at the lowest position. Be sure to operate lever (A) one or more times before switching. Do not turn the mode converter by force, otherwise it may break.< XTR / DEORE XT >Mode converterMode select switchLever (A)< SLX / DEORE >Mode converterMode select switch3. Install the inner hole cover by turning it as shown in the illustration until it stops.Do not turn it any further than this, otherwise it may damage the thread on the cover.Inner Link to comment Share on other sites More sharing options...
johannrissik Posted August 20, 2014 Share What the man said Thanks for the lesson Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now