Amberdrake

Do this. Do not offset payment even if she agrees in writing, unless its ordered and confirmed in court. If it ends up in court they ignore the agreements and just follow filed paperwork. Friend had this with his maintenance payment, he wasn't really getting paid early covid and had agreed together they will adjust etc and work on repayment plan. She ran out of cash for holiday and sued him, he was forced to take out a loan even though they had an agreement in writing. On better news after 2 years and 8 months im finally Divorced. Ex will be moving out by nov 11 if all goes well with pension payment to her (out of my hands really she has to file claim). Really relieved and somewhat disappointed it took this long as this is almost what i offered in first place. My 15 years of payments start now just for the kiddy though

Unfortunately not, i'm in somerset and took me 2 dud lawyers before one that actually got things done. Reasonable cost is very much dependant on honest and clued up part as even expensive lawyers will be worth it in end if they are honest and clued up. (considering long term costs) Divorce is messy and sucky and many many lawyers just play parties to make profit.

About 50% of the time it takes me 3 tries to get Z-Offset right, likely due to fact that I rarely do it. I went so far as to tighten bed all way and its fairly level(I did a thing with washers previously), so I don't even do a full check just a single point G28 + Load mesh. I am running UBL, don't think standard board has space for it.

I had breeze coming over printer so PETG was warping. I have enclosure now but haven't tried again so can't comment unfortunately.

Prusa is reliable and known working. There are cheaper options like Ender3 and its variants but they require lots of tinkering. Id also learn fusion 360 over onshape but its personal preference.

Even though I don't print organisers, I have many board games and a fully printed catan......

I swear same thing didn't happen for my daughters 2ed/3ed birthday's.... 3ed she got normal Elsa lego's

I used some padded sticky feet works fine, but I also have SKR1.3 plus 2209 drivers, lot less noisy/jerky than the standard board.

Well done, your well on the way to printing anything. I build Enclosure and redoing electrics to isolate atm. I Haven't printed TPU but best advice so far i have seen on any setup is go slow really really slow sub 25mm/s.

Heat Creep, Clean it all out. I found issue with my printer is a lazy fan (sunon) high quality just not providing airflow.

Cura is hit and miss these days, lot of issues with some releases Eg. on anything lower than .2 layer height it prints single lines in brim instead of proper brim(shows that way in slicer) I haven't updated to newer one as that has issues reported with circles. Prusa slicer works for now, but i do use cura as well.

Wow epic level!

oooo game that can use a joystick! I have a Logitech Extreme 3D Pro in cupboard! got 3 days to decide if i have cash to spend (Hint I don't).

I had this in overwatch once..... I muted him. The team was playing so defensively (IE defensive of themselves running away) that they were not getting close to the payload at all. I was in there as a tank all the time pushing taking hits and "feeding". Some times its just not worth it.

My condolences to your wallet it's not a cheap fix.