Jump to content

KCNC BAR ENDS


ark
 Share

Recommended Posts

 

I recently purchased a set of KCNC Bearbone bar ends.

When i fit them they either point inwards too much or outwards too much, anyone know why this is ?????

Please help.

 

Ark2010-03-01 13:39:08

Link to comment
Share on other sites

They must point inwards so they dont hook branches etc., I still hooked a fence with mine haha. 

 

Just beware of the torque settings, mine are a bit tight so I see my kcnc bar is starting to deform a bit at the clamp area
Link to comment
Share on other sites

20100301_131946_barend1.jpg

DOES THIS LOOK RIGHT ???

LOOK AT THE GAP BETWEEN THE BAR END AND THE GRIP !!

 

 

 

Link to comment
Share on other sites

no they are made to look like they do on the first pic, pointing a bit inward. 

 

Yes there is a gap but the clamping area of the bar-end is on the bar as it should be, that space is to allow for bar plugs,  get some of those, saved me the other day when i fell over from having a nice round hole in my leg...
Link to comment
Share on other sites

They should point towards the inside.What i did was i cut my my handle bar grip at an angle at the end sits flush against my bar ends. I see you have lock on grips so you can not do that.

Link to comment
Share on other sites

It looks too me like they are too on the edge. That bulge opposite the clamp should be on the bars completely.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share

Settings My Forum Content My Followed Content Forum Settings Ad Messages My Ads My Favourites My Saved Alerts My Pay Deals Help Logout