Dubber Posted October 9, 2019 Posted October 9, 2019 Also perhaps try routing it in reverse. From handle bars to seat post (or vica versa if that is what you are trying). Also try mounting the frame is different positions in you clamp. Horizontal, upside down, 45 degrees etc... Sometimes the change of frame angle is just enough to make the magic happen.
MphatiPyga Posted October 9, 2019 Posted October 9, 2019 If I remember correctly the internal cable routing on the PYGA is not fully internal, I know it is not on my 110. Internal routine is via a hole at the back above the bb and the housing should be inserted from hole towards seat tube. The rest of the routing is external under the bb and up the underside of the frame. Cable clamps should be the a triple routed type for RD, Brakes and seat post
MORNE Posted October 9, 2019 Posted October 9, 2019 Life's too short for this BS....especially if you have big hands and no asian sweatshop slaves. External routing for everything except dropper FTW PS: yey 1000 posts. i can now be trusted as a reputable buyer/seller
RobertWhitehead Posted October 10, 2019 Posted October 10, 2019 We all aspire to be reputable - except my cousin on the oil rig, avoid him by all cost Life's too short for this BS....especially if you have big hands and no asian sweatshop slaves. External routing for everything except dropper FTW PS: yey 1000 posts. i can now be trusted as a reputable buyer/seller
Recommended Posts
Archived
This topic is now archived and is closed to further replies.