Shimano hollowtech crank pin spacer

[rossouwdutoit]

Hi... Kindly could anyone point me in a direction of where in South Africa i can get one of these little pin spacers for hollowtech. Photo attached

 

Thanks

Rossi

[lechatnoir]

perhaps pop into your LBS and have a chat with them? It's very likely they have a spare lying about they won't mind giving to you.

These are fiddly and easy to lose or forget

[Barry]

I have a few in my parts bin and sure @RobertWhitehead has a handful but not sure it worth the shipping. As stated chat with the guys in the workshop at your LBS the might have in a parts/scrap bin.

[RobertWhitehead]

You know what I did to secure mine? I used a piece of wire 😁.

[Barry]

2 minutes ago, RobertWhitehead said:

You know what I did to secure mine? I used a piece of wire 😁.

Did you get sorted with the sus bolts you were looking for? I have a few bolts and a bearing kits with bolts but head saying it is Scott/Giant. I will clean my draws out over the weekend toss the content into a box same as last and you can have them.

[RobertWhitehead]

Just now, Barry said:

Did you get sorted with the sus bolts you were looking for? I have a few bolts and a bearing kits with bolts but head saying it is Scott/Giant. I will clean my draws out over the weekend toss the content into a box same as last and you can have them.

Thank you very much. I have one shop in Bloem that possibly has but they're not 100% sure just yet 😁. The brand wont be an issue

[Barry]

2 minutes ago, RobertWhitehead said:

Thank you very much. I have one shop in Bloem that possibly has but they're not 100% sure just yet 😁. The brand wont be an issue

I have a few in my scrap bin some new but like i say no idea what they from but thinking Giant Anthem. 

[Barry]

Sorry OP for the hijack🤣

[RobertWhitehead]

1 minute ago, Barry said:

Sorry OP for the hijack🤣

Thank you very much, here's the dimensions from the kind folks at Trek: 

40mm x 10mm, 29 mm top  

50mm x 10mm, 40 mm bottom

[Dexter-morgan]

3 hours ago, rossouwdutoit said:

Hi... Kindly could anyone point me in a direction of where in South Africa i can get one of these little pin spacers for hollowtech. Photo attached

 

Thanks

Rossi

I will ask my sister to laser cut them, I will see if I have a sample to give to her.

[Barry]

2 minutes ago, Dexter-morgan said:

I will ask my sister to laser cut them, I will see if I have a sample to give to her.

The laser cut will work but you will need to melt a 1.5mm drill bit into the plastic for the locating pin cut the bit at correct lenth.