zappa

Calving season: Along the new Umzilkulwana trail at Sani Spoors.

Calving season.

[You can also check out the Spaz Butcher for front & Slaughter (Grid version) at the back. Good grip on the front & not too much rolling resistance Any thoughts Slaughter front and rear?

Lekhubu Island.

Wasn't me!

Indeed, after stripping my bolt with the standard cr@ppy ones got two sets of these.

Family brought them back from USA,but you can get them ontheline. They work great.

District road looking up to Giants Cup, Himeville.

Hey Mpati. I use those Backcountry Research thingys. Work very well and secure tubes (and anything else) properly.

I'm looking for something like this but it is a bottle opener. Any ideas where available?

At last getting to grips with 2015................

Bondi Bikes, Sydney. They are dutch, maybe on the line.

Some 'Lekker' grips for the single-speed!

Incredible rock riding. Incredible gadget, the ipod touch.

Cycling in the Matopos, Zimbabwe.

And this is where it took us: Incredible Single Speed fun in the Matopos, Zimbabwe.

Funny Guys . The grassy one where all the cars parked, that one. Thanks Cycho, do you maybe have an email address?

Anybody, maybe, by some miracle, see or find Samsung Galaxy S4 Active on the 42km route or around car park. Yes I know its a long shot, but maybe, just maybe.........

Would cost you a mint to check them out in PMB anyway!

This isn't a rant, nor a name and shame, just an observation. Went to three Cycle shops to buy a Fizik Gobi saddle: Shop 1: R2550 Shop 2: R1850 Shop 3: R1295 Well worth the R20 diesel to drive the 10km radius.

Thanks Chris Take tomorrow off and have a beer! thanks, Thats what it was. Also when in doubt, RTFM (read the manual) < For Front > 2 × 10 1. Switch the mode converter to the 3x (triple mode) position, and then check the lowest position. Operate lever (B) two times or more to set the lever to the lowest position. Remove the inner hole cover, and install the cable. Note: Do not force the mode select switch to turn. If you force it to turn, it will break. < XTR / DEORE XT > Mode converter Mode select switch < SLX / DEORE > Mode converter Mode select switch Inner hole cover Lever (B) Inner cable12 2. Operate lever (A) once to set it to the middle position. Switch the mode converter to the 2x (double mode) position. Note: The mode converter cannot be switched while the lever is at the lowest position. Be sure to operate lever (A) one or more times before switching. Do not turn the mode converter by force, otherwise it may break. < XTR / DEORE XT > Mode converter Mode select switch Lever (A) < SLX / DEORE > Mode converter Mode select switch 3. Install the inner hole cover by turning it as shown in the illustration until it stops. Do not turn it any further than this, otherwise it may damage the thread on the cover. Inner

Thanks Droo, tried that. There seems to be a black plastic "thingy" in the way, preventing cable from being pushed out.