Neville Bailey

Ha ha! That’s pretty cool.

Here you go - looking good!

It's loose where the arm connects to the horizontal bar of the carrier. Thanks for the tip about the hex nut!

I have a three-bike Thule platform bike carrier. The longest of the three swing arms has become very loose over time, and I was wondering if there's a way to tighten it up.

I have a Ravemen CR1000 front light for my road bike and I am impressed with it, except for the strap mount. I would like to mount it upside down with a GoPro adapter under my Garmin Edge mount. This will look much neater and hopefully more sturdy than the strap mount. Apparently it is possible to rotate the lens 180 degrees in order to keep the T-shaped light pattern correctly oriented when mounting the light upside down. I can see a little notch on the lens bezel, but I don’t see how I can use it to rotate the lens. Do I need a special tool or is there a hack out there?

Hi Leslie, I cut a piece of hardboard to fit inside the caravan passage and then bolted some rooftop bike anchors onto the hardboard.

The start times in this document do not correspond to the WhatsApp and email messages I have received regarding my start time. The communications state that my start batch is Q at 7:50am, but according to this document batch Q starts at 7:35am. Which is it?

Here’s my race.

Bikes loaded and ready to go!

Methinks we might drive the gravel road and then park at the tar road and ride from there...

We are camping at the Van Zylsrus Caravan Park at Kuilsriver from Monday to Thursday, so a short visit. Margaret and I hope to squeeze a few rides in the mornings, nothing too hectic though.