Jump to content

Query re CO2 Bombs


RodTi

Recommended Posts

Hey all....

 

Seeing the Stans conversion thread got me thinking...

 

I recently upgrade my wheelset, and had the conversion done.

 

Touch wood - as of yet - I've had no problems.

Which means, I've yet to use my Barbieri Moskuito(?) bomb-set (?) that I bought...

 

The instructions are barely understandable - it appears as if Italian(?) English is a close second behind Japanese English - but should be ok if the need arises.

 

My question though, pertains to me hearing/reading here and there about fingers being frozen [as in sticking - as in if you were to stick your tongue against ice] to bombs/wheel/valve etc....

 

What exactly is this all about? Does it happen? Which part becomes so cold - the bomb after its been used? Must you be careful when you remove it? Or does the whole valve become frozen?

 

If this is all a myth - some clarity would be appreciated...

 

Ta!Big%20smile 
Link to comment
Share on other sites

When gas expands it cools. When it expands rapidly, it cools rapidly. EG: deoderant is cold when u spray it coz its expanding. Now, think about how much gas is in a CO2 bomb and how rapidly it expands. The rapid expansion causes the outside of the bomb (and your fingers if they're touching it) to freeze. It can cause some light burns if you're not careful...

Use a piece of tube to hold the bomb while inflating your tube

Link to comment
Share on other sites

When gas expands it cools. When it expands rapidly' date=' it cools rapidly. EG: deoderant is cold when u spray it coz its expanding. Now, think about how much gas is in a CO2 bomb and how rapidly it expands. The rapid expansion causes the outside of the bomb (and your fingers if they're touching it) to freeze. It can cause some light burns if you're not careful...

Use a piece of tube to hold the bomb while inflating your tube

[/quote']

 

So it's only the bomb?

 

And this obviously is not a problem with a screw-in bomb applicator, since the bomb is already inside the 'applicator', i.e. not in contact with your fingers....

 

Thanks!
Link to comment
Share on other sites

I've always just held the bare bomb in my glove and never had a problem. The bomb ends up with a layer of ice on it by the time you've used it but if you hold it properly then you should not have a problem.

Link to comment
Share on other sites

Hi RodTi.

 

Yes, the BOMB part becomes cold......white.  Use an old tube to pull it over the bomb for your fingers not to get stuck on the bomb.  Complements of Bicycling.
Link to comment
Share on other sites

Generally its only the bomb. Bear in mind metal conducts temperature very well, so the valve that the ice cold air is blowing into can also get very cold. I've using the barbieri pnk applicator (see pic) which is just a little valve cap that screws ontop of the bomb. I dont like the BIG applicator that covers the bomb - i'm a weight weenie sometimes Tongue

http://www.barbieripnk.it/jetsetgr.gif
Link to comment
Share on other sites

Like Spinnekop said, it appeared in the Bicycling mag a few issues ago -besides protecting your hands from freezing, it also stops any knocking sound in your tubby bag or back pocket (the tube over the bomb).

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Settings My Forum Content My Followed Content Forum Settings Ad Messages My Ads My Favourites My Saved Alerts My Pay Deals Help Logout