Jump to content

Double wrapping bar tape


Kalahari Vegmot

Recommended Posts

Posted

I tried that, and the top layer was a tad too short - the extra thickness to wrap meant i had to skimp on the overlap wrapping on the top layer.

 

So what I did is just wrap the tops with two layers and the drops with one. So from the levers towards the stem... that has a double wrap. It means I have enough to double wrap as the drops are only single. I'm OK with that. I used some old silicon wrap i had taken off as my bottom wrap and it works just fine

Posted

I tried that, and the top layer was a tad too short - the extra thickness to wrap meant i had to skimp on the overlap wrapping on the top layer.

 

So what I did is just wrap the tops with two layers and the drops with one. So from the levers towards the stem... that has a double wrap. It means I have enough to double wrap as the drops are only single. I'm OK with that. I used some old silicon wrap i had taken off as my bottom wrap and it works just fine

I do the same. 

Posted

Been thinking of double wrapping my bar tape; and tought that perhaps instead of using two layers of bar tape, why not cut up an old innertube for the base layer?

 

What do you guys think?

Could work, but bar tape has a bit of adhesive. The tube may slip

Archived

This topic is now archived and is closed to further replies.

Settings My Forum Content My Followed Content Forum Settings Ad Messages My Ads My Favourites My Saved Alerts My Pay Deals Help Logout