Johan A Marais Posted August 25, 2016 Posted August 25, 2016 Can anyone help with a tip or trick on how to get branding that has gone bad off bibs which are pretty much still new and in good working condition. Some of the branding starts to flake/crack after a couple of washes and just looks pretty horrible...
droo Posted August 25, 2016 Posted August 25, 2016 From that thread title I thought you were asking advice on a completely different subject. In which case the advice above would be a good start too. As you were.
TIB Posted August 25, 2016 Posted August 25, 2016 From that thread title I thought you were asking advice on a completely different subject. In which case the advice above would be a good start too. As you were.
Long Wheel Base Posted August 25, 2016 Posted August 25, 2016 From that thread title I thought you were asking advice on a completely different subject. In which case the advice above would be a good start too. As you were.Your mind is in the gutter. With mine
NicoBoshoff Posted August 25, 2016 Posted August 25, 2016 From that thread title I thought you were asking advice on a completely different subject. In which case the advice above would be a good start too. As you were.Begs the question...how did the flaking occur? I'll show myself out thanks...
snakedoc Posted August 25, 2016 Posted August 25, 2016 Did ironing the bib start it to flake? If it did, maybe iron it again, warming it up and slowly peel off? I have no idea if this will work just trying to apply some logic
droo Posted August 25, 2016 Posted August 25, 2016 On the actual subject though, the solvent usually used in screenprinting is acetone. It may dissolve the lycra too though, so maybe test on an old pair first.
BeegMig Posted August 25, 2016 Posted August 25, 2016 Pull it off, carefully,, patiently or wash it a few time more, since that started the flaking maybe that will cause more
2 X 2 Posted August 25, 2016 Posted August 25, 2016 From that thread title I thought you were asking advice on a completely different subject. In which case the advice above would be a good start too. As you were. Ha ha, had a lekker laugh
Johan A Marais Posted August 25, 2016 Author Posted August 25, 2016 I knew the title will most probably get some attention. LOL - if nothing comes from this, at least a good laugh did - eish. This is a tough world, Africa is not a place for sissies...
Edge540 Posted August 25, 2016 Posted August 25, 2016 I knew the title will most probably get some attention. LOL - if nothing comes from this, at least a good laugh did - eish. This is a tough world, Africa is not a place for sissies... Africa is ok. It's just the Hub that nails you
popcorn_skollie Posted August 25, 2016 Posted August 25, 2016 Begs the question...how did the flaking occur? I'll show myself out thanks... http://www.willreadforfeels.com/wp-content/uploads/2016/07/a-gentleman-never-tells-fb-share.jpg
Patchelicious Posted August 25, 2016 Posted August 25, 2016 Your mind is in the gutter. With mine Rather ones mind than ones bicycle mid race!
BenReaper Posted August 25, 2016 Posted August 25, 2016 Did ironing the bib start it to flake? If it did, maybe iron it again, warming it up and slowly peel off? I have no idea if this will work just trying to apply some logic Ironing bibs............? Sent from my S40 using Tapatalk
Recommended Posts
Archived
This topic is now archived and is closed to further replies.