Jump to content

Recommended Posts

Posted
15 hours ago, love2fly said:

It's not the puncture vulnerability but the pressure loss in 24 hours. Like I said, I only used to pump my previous ones once a week....

Do you have latex tubes? They are known to lose pressure quikly. Butyl tubes should not be losing pressure that quickly.

  • Replies 32
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted
4 hours ago, Gr3mlin131 said:

Do you have latex tubes? They are known to lose pressure quikly. Butyl tubes should not be losing pressure that quickly.

Have no idea, bought a Kenda at Cyclelab and inherited a Spez, need to do some research...

Posted (edited)
6 hours ago, The Ouzo said:

I've not had problems with Kenda at all, actually I think I may be running one in the rear at the moment and I only top that up maybe once a month.

Do you not perhaps have some small leaks ? because even the cheapest tubes tend to hold air for longer than 24 hours when not punctured.

Brand new Kenda. And I add 100ml sealant just as insurance

Edited by love2fly
Posted

I have used the cheapest non brand /super market tubes in both road and mtb wheels and never experienced a tyre not holding pressure for less than 24 hours . Kenda tubes have always been good to me and not let me down . Punctures are not the fault of the brand of tube you use but were  and how careful you ride . As tyres wear thinner they are more subject to punctures from glass , sharp stones and shards of metal .Im currently using Pirelli tubes on my Monson HT ( slick 29 X  1.40  tyres and pireli 700x40  tubes ) and ride every day . I might pump those tyres once a month to 4 bar . 

Posted
6 hours ago, Mamil said:

I find that some tubes leak a little more than others without any correlation with brand

Can attest to this, 2 new tubes that are around 2/3 weeks old and the one is slightly lower in terms of pressure than the other, not talking a lot, but enough to warrant double checking it.

Posted

I don't care which tube it is, cheap or expensive. Pump both up then stick a thorn in each and see which one wins the deflation race. Despite winning, both contestants will be deflated😂. Over about 7 years, I have had more punctures (3) on my car tyres (due to unavoidable potholes) than on my bike tyres.

Posted
18 minutes ago, tjommies3 said:

I don't care which tube it is, cheap or expensive. Pump both up then stick a thorn in each and see which one wins the deflation race. Despite winning, both contestants will be deflated😂. Over about 7 years, I have had more punctures (3) on my car tyres (due to unavoidable potholes) than on my bike tyres.

Definitely not a puncture. Double checked and each has around 100ml Enduroseal for peace of mind. That way I get maybe 1 puncture a year with Gatorskins.

I'm off the bike for the next 12 weeks due to a Brachytherapy procedure but will try some Conti tubes when I'm back 😎

19 hours ago, Mongoose! said:

If valve cores are removable, make sure they are tighten. 

Yip, I do that with the tool.

Posted
20 hours ago, Mongoose! said:

just makes a mess.

the inside of a tube is different from the inside of a tyre - maybe it is that white powder?

the friction between the tire and tube makes it impossible to seal from inside

Trust me, I have tried it with many different variations.  

On a road tire the volume is small and pressure high  ... mtb vice versa bigger volume lower pressure

I’ve seen tubes sold off the shelf with sealant already in it. I have buddies that use this and swear by it. Even have one extra in their saddle bag. Maybe those don’t have the white powder? 🤷🏻‍♂️

Posted

I use these, only requires a little pomp maybe every 3 weeks. I’m a heavy Ike so like the firmness of 7bar at 6bar I feel it’s a bit too bouncy for my liking.

i use the 60mm in a 50mm profile wheel.

image.jpg

Posted
11 minutes ago, throttles said:

I’ve seen tubes sold off the shelf with sealant already in it. I have buddies that use this and swear by it. Even have one extra in their saddle bag. Maybe those don’t have the white powder? 🤷🏻‍♂️

I prefer Enduro seal also in my MTB - It's never let me down

Posted
9 minutes ago, throttles said:

I use these, only requires a little pomp maybe every 3 weeks. I’m a heavy Ike so like the firmness of 7bar at 6bar I feel it’s a bit too bouncy for my liking.

i use the 60mm in a 50mm profile wheel.

image.jpg

That's the one..... 👍

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Settings My Forum Content My Followed Content Forum Settings Ad Messages My Ads My Favourites My Saved Alerts My Pay Deals Help Logout