TNOSE_E

Is this all to do with the Hub melting or the balance bangle??? So which is it?

You can also try the following: Smear some sealant along the beads of both sites of the tyre. Mount the tyre and pull the sidewalls out away from each other at the same time, as if trying to seat the tyre without using air. You will some times hear a click/pop sound as the bead pops into the rim side wall. Try this all the may round as best possible. This tends to give the tyre a bit of a pre "seat" and less air escapes when trying to inflate for the firts time. Give the tyre a blast with the compressor. If you have a removable core take it out to add extra air to the inflation. Also push down compressing the tyre flat against the the rim by the valve.

Brighterlights... PM him

Hi All A question on Disk brake pads. What are the differences between the types of material used? This is worse than shopping for bread at Woolworths! Metal Semi - Metalic Resin Sintered Ceramic Organic Breaking power? Heat buildup? Wear?

If your HR is not unusually elevated during effort, then you are good to go. But start off slow.

The route is quite good when dry! I rode the route yesterday including the sections closed off due to mud etc. And I see why they cut some sections, they are unridable! So not much they could do. I see they even left the spar and repril gel banners there for the homless. So a thought might be to move the event to a date out of the rainy season if possible. But as the MTB event is just a opening act for the Road race I'm not holding my breath.....TNOSE_E2010-02-10 04:06:12

Prob the bot boss.... Anyone with enough know how can write an algorithm to randomly dial numbers of a counter. Add some VOIP software, connect to a modem and bobs your bot. Actually have no idea, but could be your neighbor....

I see there is now a bot that randomly dials network mobile numbers. If answered the number is logged and sold to marketing co. You will know its a bot if the line just cuts after a few seconds after answering. Already too late.... The telesales people even leave messages now for you to call back or visit a certain store....

Ja, will prob be there again.

You can get 15W and 5W from your local Motorbike shop. Seals and orings order from Lbs.

Both of mine did. Let us know how it goes.

Got clear and dark from another source and the lense coating on both started peeling after 3 rides.

Yellow will be faster for sure.

Family owned, family run , family staffed and family stocked.....

brake cleaner is only for the disk.

My spinner is setup close to my MTB with spd's. Planning on attaching a MTB flatbar in place of the spinners hand grips/bar thingys.

Spinning bike works for me. No need to hassle with slicks on the MTB and extra wear and tear on bike components.

Going on 3 months now getting a reba repaired between the bike shop and RS agents. Still don't have the thing? Can anyone say runarrrround....

Where, when and what route?

Bahama Blue works for skin repair for sure!

Just found this thread now. Heal quick little dude!

Keen

Another birdy told me that some people gets their parcels marked different to the actual content' date=' to pay less duties. Maybe customs picked up on this?[/quote'] Could be. not sure what the exact buhi was about.

a little bird told me that some LBS have laid some complaints against CRC with customs....